How semi-automatic screen printing machine on photosensitive adhesive

1. Check whether the photosensitive adhesive is enough, generally 1/4 is enough, if not enough, re-prepare the photosensitive adhesive.

2. Pour the sensitized glue into the sizing machine of the semi-automatic screen printing machine until it reaches 2/3 full. Hold the balance between the two sides of the sizing device with the right hand. Hold the lower frame of the screen frame on the clean floor. , Screen and the ground into a 45-degree angle, from the bottom upward gluing; sizing and mesh angle of 45 degrees; only from the bottom up, not coated with the part again sizing, until there is a full surface of sensitive adhesive And it's very even.

3. The screen plate coated with photo resist, the mesh cloth is placed flat on the semi-automatic screen printing machine. After about 10 minutes, no water droplets were visible on the mesh; when there were no water droplets on the surrounding frame, the screen was dry. Can be on the second pass of photosensitive adhesive. After drying, you can print.